Guide to power

MARK 2 Hanley Messer Deuterium Fusion Drive guide

NAVLOGCOM Provides the basic Steps for the Marine on how to safely start up a a standertd UNSC Ship/station Reactor

heres a picture of the hole setup from the UNSC bertels it contains the Henley Messer fusion reactor and its connected Air coolers

the middle block is the fusion reactor while the 3 yellow boxes are the reactor Coolers

How to use reactor: step one: turn on coolers and set up to like 50kpa

step two: grab a fuel pack from the creates and place it in the fusion reactor (you can place it in an empty reactor via left clicking it with fuel pack in hand)

this a reactor with fuel pack

when you left click on the Reactor/drive your gonna see this interface

congrats your making power now for you ship or base you can modify the rate of fusion depeding on how mutch engery you need, if you want to know the best setting for the reactors , ask some from your fraction or on the discord, usaly if you set too 0,5 fussion rate it will last the round easily without blowing up